Allenheath WZ14-4-2 User Manual download pdf (Page 18)

18 WZ14:4:2 USER GUIDE

REAR PANEL LAYOUT

SPECIFICATIONS

0 dBu = 0.775 Volts rms 0 dBV = 1 Volt rms

HEADROOM:...............................................+21dB channels

...............................................................+23dB mix to output

MAX OUTPUT: Balanced ........+25dBu 2kohm max load

Unbalanced ....+21dBu 2kohm max load

METERS

: L, R.................peak reading 12 bar LED

PEAK LEDs: ............................ Turn on 5dB before clipping

FREQUENCY RESPONSE:............. 20Hz to 50kHz +0/-1dB

DISTORTION: THD+Noise at +14dBu 1kHz

Channel to mix output ............................................... 0.006%

WEIGHT

: unpacked 11kg, packed 14kg

CROSSTALK:

Referred to driven channel at 1kHz

Channel fader off ....................................................... <-90dB

Channel off ................................................................ <-90dB

NOISE: Measured rms 22Hz to 22kHz bandwidth

Mic input EIN (150 ohm source) .............................. <-128dB

LR output residual noise.......................<-97dBu (101dBS/N)

LR faders unity mix noise ................... <-87dBu (-91dB S/N)

POWER SUPPLY: internal, linear regulated

AC Mains input: ...................... IEC socket with lead supplied

...................................................100 to 240V AC @ 50/60Hz

............................................. factory wired to country voltage

Power consumption: ...............................................35W max

Mains Fuse rating: ..................100-120V AC T630mA 20mm

................................................220-240V AC T315mA 20mm

CONNECTIONS

INPUTS:

Channel 1-10 in............ XLR.............................. pin 2 hot, 3 cold, bal ..................PAD out ........... 2k ohm variable -60 to -20dBu

..................................... TRS jack ...................... tip hot, ring cold, bal ..................PAD in ............. >10k ohm variable -30 to +10dBu

Stereo 11/12-13/14 in... TRS jack (L/M,R) ......... tip sig, ring gnd, unbal ...............>10k ohm......... -20 to +10dBu

..................................... RCA PHONO ............... unbalanced................................>10k ohm......... -20 to +10dBu

Stereo return ................ TRS jack ...................... tip sig, ring gnd, unbalanced .....>10k ohm......... -10dBV minimum

2-Track return............... RCA PHONO ............... unbalanced................................>10k ohm......... variable -10dBV minimum

Talkback mic in ............ XLR.............................. pin 2 hot, 1 cold, unbalanced ....2k ohm............. variable -40 to -15dBu

INSERTS:

Channel 1-10 Insert...... TRS jack ...................... tip send, ring return, unbal.........<75 ohm, >3k ohm 0dBu

L-R mix/groups............. TRS jack ...................... tip send, ring return, unbal.........<75 ohm, >7k ohm -2dBu

OUTPUTS:

L,R/Groups out............. XLR.............................. pin 2 hot, 3 cold, balanced .................... <75 ohm..........+4dBu

Mono out ...................... XLR.............................. pin 2 hot, 3 cold, balanced .................... <75 ohm..........+4dBu

Aux 1-6 out.................. TRS jack ...................... tip hot, ring cold, balanced .................... <75 ohm.......... +4dBu

2-Track send ................ RCA PHONO ............... unbalanced............................................ <75 ohm..........variable -10dBV minimum

Phones out ................... TRS jack ...................... tip left, ring right..................................... for stereo headphones 30 to 600 ohms

Channel direct out ........ TRS jack ...................... tip hot, ring cold, impedance balanced.. <75 ohm...........0dBu

1 2 ... 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Allenheath WZ14-4-2 User Manual Page 18

Comments to this Manuals

Related products and manuals for Control panel Allenheath WZ14-4-2