Allenheath XONE 42 User Manual download pdf (Page 12)

Allen & Heath 12 XONE:42 User Guide

PHONO / LINE INPUT CHANNELS 1 and 4

Channel Fader

A high quality, smooth travel dual-rail fader adjusts the

channel signal level from fully off to fully on.

XFade Switch

Used to assign the channel to either the X (left) or Y

(right) side of the cross-fader. Works in conjunction

with the XFADER On switch in the master section.

A bi-colour LED indicator illuminates either green (X)

or red (Y) to show which side of the cross-fader has

been selected.

Channel Meter

Displays the channel signal level. It is pre-EQ and pre-

fader, allowing the input level to be displayed even if the

EQ is set to off on all bands. To view the post EQ level,

press the cue switch and use the mix/monitor meters.

The channel level control should be set so that the me-

ter averages around ‘0’ with loudest peaks no higher

than ‘+6’. Turn down the level control if the +10 peak

indicator lights.

Cue Switch

Press the Cue switch to listen to the channel pre-fade

signal in the headphones and see its level on the main

meters. The LED indicator next to the switch lights

when selected. The Cue LED indicator in the monitor

section also lights to warn that you are monitoring the

channel signal rather than the main mix. Press the

switch to deselect cue.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Allenheath XONE 42 User Manual Page 12