Allenheath XONE 42 User Manual download pdf (Page 15)

Allen & Heath 15 XONE:42 User Guide

FILTER SECTION

Frequency Sweep Control

This control sets the –3dB cut-off frequency of the filter.

It ranges from very low frequency (20Hz) to very high

frequency (20kHz).

NOTE: Both BPF and HPF filters are band limited to

prevent them going above 10kHz.

VCF to Crossfader

Press this switch to assign the filter to the crossfader. The

crossfader can then be used instead of the FREQ VCF

sweep control to create filter effects whilst crossfading.

The yellow LED next to the switch illuminates to indicate

that this control is active.

While using the crossfader to sweep the VCF frequencies,

the sweep control ranges from the left-hand (X) side of

the crossfader to the mid-point.

Disabling the crossfader will also disable this function.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

No comments

Allenheath XONE 42 User Manual Page 15